top of page
ana sayfa
ADHESIVES
HOT MELT
Hot Melt Adhesives
Hotmelt adhesives (HMA), also known as hot glues, are generally 100% solids formulations based on thermoplastic resins. They are solid at room temperature and can be softened, reshaped, and dispensed upon heating above their softening point. Solidification takes only seconds after dispensing, or in other word, these thermoplastic adhesives reach full strength once they cool to room temperature. This minimizes clamp time and allows for rapid assembly. Hot melt adhesives are also easy to clean with low to no toxicity and the application and bonding can easily be automatized. Furthermore, they have excellent gap filling capabilities and bond a wide variety of porous and non-porous substrates including pre-painted steel and polyolefin plastics.
Solvent Bazlı
Solvent Based Adhesives
Solvent-borne contact adhesives based on polyurethane (PU or PUR) are characterised by resistance to plasticisers and good adhesion to the most different materials (except bare metal). Therefore they are used for bonding soft PVC to each other as well as to many other materials. Similar to CR adhesives, they can also be reactivated by heat (e.g. in vacuum deep-drawing methods for the lamination of formed parts with flexible top layers).
Yavaş Tepkili
Viscoelastic foams
Viscoelastic foams have two main catagories, the first one is that the foam is impregnated by special resins. The other is that the foam itself has viscoelastic properties gained by special formulation of polyols and isosyanates. Both are in our production range. Both types have vibration deadening properties.
Viscoelastic foams
Viscoelastic foams have two main catagories, the first one is that the foam is impregnated by special resins. The other is that the foam itself has viscoelastic properties gained by special formulation of polyols and isosyanates. Both are in our production range. Both types have vibration deadening properties.
yüzey gerilim sıvıları
Surface Tension Control Liquids
Complies with ASTM standards. They are used to test surface tensions of mainly PP and PE molded parts.within the range 30-56 dynes/cm
kağıt conta
Paper Seal
Cellulose based seals produced by 7-21N/mm2 indentation hardness.
bottom of page